This content was compiled automatically and has not yet been reviewed by a technician. For reference only.
For reference only. Always confirm part numbers and procedures for your specific vehicle.
Fault diagnosis
Maxus eT9: DC fast charging still will not start after repeated attempts
DC fast charging still cannot charge after three consecutive attempts.
Maxus eT9: DC fast charging still will not start after repeated attempts
Symptoms
- DC fast charging still cannot charge after three consecutive attempts. [1]
Possible causes
- The original charging equipment may be damaged; a connector that is not fully inserted can prevent the electronic lock from locking. [1]
Checks
- Before fast charging, switch off vehicle power and wait 3–5 minutes; have charging station personnel check the equipment and connection. After three consecutive failures, try another unit. Switch off power to the charging equipment before unplugging the connector. [1]
What to do
- Use matching charging equipment in normal working order, and follow the manual for power-off waiting, connection and locking, and stopping charging; if charging succeeds with another unit, the original equipment may be damaged. [1]
Applicability and limits
- Only applies to the DC fast charging procedure in the English eT9 manual on the Maxus Switzerland official website; charging station personnel must operate it as required by the manufacturer. Do not extend to other models. Scope: unknown [1]
Sources
[Source 1] SAIC MAXUS eT9 Driver’s Handbook (English edition from the Switzerland official website) — printed pp.126–127; PDF pp.134–135; Fast charging, steps 6–7 and notes (accessed 2026-10-30)
https://www.maxusmotors.ch/images/bedienungsanleitungen/DE/eT9-user%20manual-20241008-EN-compressed.pdf
Related Academy Articles
Fault diagnosis
Rough idle: electronic EGR valve sticking inspection clues
The engine idles roughly (rough idling) or hesitates during acceleration.
Fault diagnosis
Engine stalls or enters emergency mode: airflow meter inspection clues
The engine stalls or the control unit enters an emergency program, possibly with the engine warning light on.
Fault diagnosis
Charging indicator does not light with ignition on and engine stopped
The ignition is switched on and the engine is not yet running, but the charging/battery indicator does not light.