This content was compiled automatically and has not yet been reviewed by a technician. For reference only.
For reference only. Always confirm part numbers and procedures for your specific vehicle.
Fault diagnosis
Changan CS75 PLUS: Coolant below MIN when cold or continuing to fall after topping up
Coolant is below MIN when checked cold, or the level continues to fall.
Changan CS75 PLUS: Coolant below MIN when cold or continuing to fall after topping up
Symptoms
- Coolant is below MIN when checked cold, or the level continues to fall. [1]
Possible causes
- The manual specifies the cold fluid level range and rechecking after topping up, and warns that air entering through improper handling causes overheating; it does not identify a failed water pump. [1]
Checks
- Check the levels in the corresponding high-/low-temperature circuits when fully cooled; have a service provider identify the cause if the abnormality persists. [1]
What to do
- Repair according to this version's coolant and circuit requirements; do not open the cap while pressurised or infer a failed component on your own. [1]
Applicability and limits
- Only applies to the corresponding CS75 PLUS configuration in the Russian-language CS75plus manual from the official Russian website, revised June 2024; the manual date is not treated as an applicable model year. No actual vehicle model has been linked. Do not extend to vehicles with the same model name, other powertrains or other markets. Scope: unknown [1]
- Only applies to the specific configuration in the cited manual; do not assume applicability to all vehicles with the same model name.
Related part categories
- Fluids / Coolant / Cooling system [1]
Sources
[Source 1] CHANGAN CS75plus Official Russian-language Owner's Manual (revised June 2024) — PDF pp.191–192 / printed pp.189–190, Охлаждающая жидкость двигателя (accessed 2026-11-01)
https://changanauto.ru/storage/model/manual/WSgnpgLSAb6KH8FbBDMEjFC1KkjFveFgUSeRPynd.pdf
Related Academy Articles
Fault diagnosis
Rough idle: electronic EGR valve sticking inspection clues
The engine idles roughly (rough idling) or hesitates during acceleration.
Fault diagnosis
Engine stalls or enters emergency mode: airflow meter inspection clues
The engine stalls or the control unit enters an emergency program, possibly with the engine warning light on.
Fault diagnosis
Charging indicator does not light with ignition on and engine stopped
The ignition is switched on and the engine is not yet running, but the charging/battery indicator does not light.