This content was compiled automatically and has not yet been reviewed by a technician. For reference only.
For reference only. Always confirm part numbers and procedures for your specific vehicle.
Air Conditioning and Thermal Management
2026 Tiggo 9 second-row vents: distinguish the centre tunnel, footwell and B-pillar positions
Australian MY26 Tiggo 9 lists second-row centre-tunnel, footwell and B-pillar vents. Identify the location before selecting a rear vent.
2026 Tiggo 9 second-row vents: distinguish the centre tunnel, footwell and B-pillar positions
A rear vent's vanes need attention, but the photograph does not show whether the vent is on the centre tunnel or beside a door. For the Australian MY26 Tiggo 9, explicitly identifying a B-pillar location helps match the candidate vent to the vehicle.
The factory lists three second-row positions
Page 4 identifies second-row vents at the centre tunnel, footwell and B-pillar, with third-row vents listed separately. Both trims have the corresponding entries. [Factory technical table][S03] “Rear vent” is not a sufficiently specific physical-part name.
Multiple outlets do not establish multiple independent temperature zones or blowers. The product table identifies positions here; internal ducting still requires separate verification.
Small trim parts also need a wider location photograph
Show the side, row and interior area containing the vent before photographing the vanes or other damage. If the request arises from changed airflow, record the current settings and workshop findings separately rather than treating airflow behaviour and damaged vanes as one cause.
Record the vent itself, surrounding trim and any confirmed related item separately. Retaining the B-pillar location makes it easier to check parts against the vehicle's actual installation.
The additional Tiggo 9 restriction is the factory specification for production from Jan 2026. This production restriction does not replace the explicit MY26 designation.
Scope and verification
This article is limited to Australia, MY26, Chery TIGGO 9, Super Hybrid Elite and Super Hybrid Ultimate; specifications for production from Jan 2026 only. [Model year and configuration][S03] Factory equipment information identifies functions and parts; it is not a fault or replacement criterion.
No public data were available in the reviewed material for upper/lower and left/right supply of B-pillar vents, duct connections, temperature-control functions, removal and installation, and test parameters; OE numbers, repair parameters, separate parts availability or compatibility and interchangeability. [To be verified] Compatibility or interchangeability must be checked using the vehicle identification number (VIN) and the local factory parts catalogue in Australia.
For parts discussed here, use the parts enquiry page.
[S03]: https://cherymotor.com.au/sites/default/files/2026-05/271_25_Tiggo_9_PHEV_Spec_Sheet_v104.pdf
Related Academy Articles
Air Conditioning and Thermal Management
Electric A/C compressor oil: why a specified POE system cannot use a generic substitute
DENSO guidance for specified ND-oil 11 systems covers oil mixing and insulation risks. Refrigerant compatibility alone does not establish oil suitability.
Air Conditioning and Thermal Management
Battery chiller or cabin evaporator: clarify a repair order that only says cooler
Identify the system and heat-transfer media before ordering a cooler. Battery chillers and cabin evaporators perform different roles.
Air Conditioning and Thermal Management
2026 Tiggo 9 automatic defogging: a function name does not identify a humidity sensor
Australian MY26 Tiggo 9 lists Automatic Defogging. The function name does not establish sensor identity, heated glass or fault thresholds.