This content was compiled automatically and has not yet been reviewed by a technician. For reference only.
For reference only. Always confirm part numbers and procedures for your specific vehicle.
Tyres, Wheels and Bearings
2025 Cyberster tyres: front and rear specifications differ, beyond 19 or 20 inches
Australian MY25 Cyberster RWD and AWD use different front and rear tyre specifications. Record the full size, drive configuration and axle position.
Ordering tyres with only “Cyberster, 19 inches” may leave the front or rear position unspecified. The Australian MY25 model uses different specifications at these positions. Recording the complete size is more useful than searching by rim diameter alone.
Each drive configuration has front and rear specifications
The manufacturer table lists RWD front 245/45R19 and rear 275/40R19; AWD front 245/40R20 and rear 275/35R20.[Manufacturer specifications][Q01] These records apply to the two Australian MY25 configurations. They are not universal conditions for every Cyberster or another market.
A procurement request should therefore retain at least the drive configuration, front/rear position and full specification. R19 or R20 alone is not a complete identity; neither is a bare 19 or 20 inch description.
Front and rear on one vehicle are not automatically the same item
The table itself shows the differences. Having four original wheels does not establish direct front-to-rear interchangeability of tyres or wheels. Tyre rotation or wheel supply requires separate corresponding information; the table does not supply wheel offset or mounting dimensions. [To be verified]
Record the actual condition of vehicles with previous wheel changes or modifications separately. Do not assume a currently fitted item proves the original manufacturer specification.
A size table provides no wear acceptance limit
This article helps reduce position and size ordering errors. Original dimensions do not determine whether the current tyre remains serviceable. Wear, damage and other safety checks require professional attention under the applicable information. This article invents no replacement mileage or front-to-rear rotation interval.
Scope and verification
This article covers only Australian MY25 MG Cyberster: 77kWh RWD and 77kWh AWD. The cited feature and equipment information is not a fault or replacement criterion.[Scope reference][Q01]
No public data was available in the reviewed material for specific wheel identity, offset/bolt pattern, load capacity or tyre repair and replacement requirements; front-to-rear rotation rules, repair parameters, OE numbers, separate parts availability or interchangeability between trims. [To be verified] Check compatibility or interchangeability using the VIN and the local Australian manufacturer parts catalogue.
For the parts discussed here, use the parts enquiry page.
[Q01]: https://mgmotor.com.au/brochures/MG_CYBERSTER_2026_v2.pdf
Related Academy Articles
Tyres, Wheels and Bearings
OMODA 5 tyre-pressure warning: does tyre replacement also require a new sensor?
Distinguish low pressure, signal loss and system faults, and assess valve service parts separately from the complete TPMS sensor.
Tyres, Wheels and Bearings
2026 Tank 300 Spare Wheel Cover: Separate Cover Damage from Tyre and Wheel Requirements
Identify MY26 Tank 300 Luxury spare-wheel cover damage separately without assuming cover dimensions or separate parts availability.
Tyres, Wheels and Bearings
Haval JOLION Humming While Driving: Distinguishing Tyre Clues from Wheel-Bearing Findings
A JOLION humming noise alone cannot establish bearing failure. Separate road, tyre and wheel-end findings before deciding on replacement.